NetComm N300 - Manual (Page 40)

ADSL2+ Wireless N300 Modem Router with VoIP User Guide YML9WMAXXN
40 www.netcomm.com.au
Management
7.1 Device Settings
The Device Settings option allows you to back up your settings to a file, retrieve the setting file, and restore the settings.
7.1.1 Backup
The Backup option under Management > Device Settings saves your router configurations to a file on your PC. Click Backup Settings
in the main menu. You will be prompted to define the location of the backup file to save. After choosing the file location, click Backup
Settings. The file will then be saved to the assigned location.
7.1.2 Update
This option updates your router settings using a previously saved settings file.
7.1.3 Restore Default
Clicking the Restore Default Configuration option in the Restore Settings screen can restore the original factory installed settings (see
section 3.3 Default Settings).
NOTE 1: This option has the same effect as the hardware reset-to-default button on the rear panel of the router. The device board hardware and the boot loader support the
reset to default button. If the reset button is pressed for more than 10 seconds, the configuration data will be erased.
NOTE 2: Restoring system settings requires a system reboot. The current Web UI session must be closed and restarted. Before restarting it, the IP configuration may need to
be configured with a static IP address.
After the Restore Default Configuration button is selected, the following screen appears. Close the window and wait for 2 minutes
before reopening your web browser. If necessary, reconfigure your PC IP address to match your new configuration.
7.1.4 Update Firmware
The Update firmware screen allows you to update the firmware of the device. Manual firmware upgrades from a locally stored file can be
performed using the following screen. Your ISP will provide this file to you, if necessary.