beautypg.com

Operation, Halogen bulbs – NuTone NP51000 User Manual

Page 11

background image

- 11 -

OPERATION

Controls

The hood is operated using the slide controls
under the bottom of the hood.

The light switch turns the lamps on and off.

The blower switch :makes it possible to
select the motor operating speed. Position 0:
motor off.

The pilot lamp lights up whenever the blower
is on.

HEAT SENTRY™
Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a
device that will turn on or speed up the blower if it senses excessive heat above
the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature level drops to normal, the blower will return to its original
setting.

WARNING
The HEAT SENTRY thermostat can start the blower even if the hood is turned
OFF. When this occurs, it is impossible to turn the blower OFF with its switch.
If you must stop the blower, do it from the main electrical panel.

LIGHT

SWITCH

PILOT

LAMP

BLOWER

SWITCH

HALOGEN BULBS

This range hood requires two halogen bulbs
(Type JC, 12Volt, 20 Watt Max, G-4 Base).
ALWAYS SWITCH OFF THE ELECTRICITY
SUPPLY BEFORE CARRYING OUT ANY
OPERATIONS ON THE APPLIANCE.

To change bulbs:

1. Loosen the ring nut by turning it

counterclockwise.

2. Remove the bulb by pulling sideward(DO

NOT ROTATE). CAUTION: BULB MAY BE
HOT!

3. Replace with Type JC, 12Volt, 20 Watt

Max, G-4 Base halogen bulb. Do not touch
replacement bulb with bare hands!

RING NUT

This manual is related to the following products: