NetComm Wireless Access Point NP720 - Manual (Page 8)

Introduction
5
Rear Panel
Figure 3 Rear Panel
Antenna One antenna (aerial) is supplied. Best results are usually obtained with
the antenna in a vertical position.
Console port DB9 female RS232 port.
Reset Button This button has two (2) functions:
• Reboot. When pressed and released, the Wireless Access Point
will reboot (restart).
• Reset to Factory Defaults. This button can also be used to clear
ALL data and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Hold the Reset Button down until the Status (Red) LED blinks
TWICE, usually more than 5 seconds.
2. Release the Reset Button.
The factory default configuration has now been restored, and the
Access Point is ready for use.
Ethernet Use a standard LAN cable (RJ45 connectors) to connect this port to a
10BaseT or 100BaseT hub on your LAN.
Power port Connect the supplied power adapter here.