NetComm Wireless Access Point NP720 - Manual (Page 21)

Wireless Access Point User Guide
18
VLAN Configuration Screen
This screen is accessed via the Configure VLAN button on the Security Profiles screen.
• The settings on this screen will be ignored unless the Use VLAN option on the Security
Profiles screen is selected.
• If using the VLAN option, these setting determine which VLAN traffic is assigned to.
Figure 11: VLAN Configuration
Data - VLAN Configuation Screen
Profile Each profile is listed by name.
VLAN ID Enter the ID for the required VLAN. All traffic using this profile will be
assigned to this VLAN.
AP Traffic
No VLAN Tag Traffic generated by this AP will not have a VLAN tag (no VLAN ID).
Replicate
packets… If selected, each packet generated by this AP will be sent over each
active VLAN, as defined in the client VLAN table above. This requires
that each packet be replicated (up to 8 times). This has a detrimental
effect on performance, so should only be used if necessary.
Specified
VLAN ID If selected, you can enter the desired VLAN ID. Normally, this ID
should be one of the client VLAN IDs defined above.