beautypg.com

Preparing the remote control, Identification of controls – NAD T562 User Manual

Page 7

background image

ENGLISH

FRANÇAIS

DEUTSCH

NEDERLANDS

ESP

AÑOL

IT

ALIANO

POR

TUGUÊS

SVENSKA

7

PREPARING THE REMOTE CONTROL

Insert the batteries into the remote control so you can use it to operate the T562.
1 Open the battery cover
2 Insert two batteries (AAA size)
3 Make sure to match the + and - on the batteries to the marks inside the battery compartment.
4 Close the cover

NOTES ON BATTERIES
Improper use of batteries may cause battery leakage and corrosion.
• To operate the remote control correctly, follow the instructions.
• Do not insert the batteries into the remote control in the wrong direction.
• Do not charge, heat, open or short-circuit the batteries.
• Do not throw the batteries into fire.
• Do not leave dead or exhausted batteries in the remote control.
• Do not use different types of batteries together, or mix old and new batteries.
• If you do not use the remote control for a long period of time, remove the batteries to avoid possible

damage from battery corrosion.

• If the remote control does not function correctly or if the operating range becomes reduced, replace

all batteries with new ones.

• If battery leakage occurs, wipe the battery liquid from the battery compartment, then insert new

batteries.

• The batteries should last about one year with normal use.

OPERATION OF THE T562 WITH THE REMOTE CONTROL

This section shows you how to use the remote control. Point the remote control at the remote control
sensor and press the buttons.

Distance: About 23 ft (7 m) from the front of the remote sensor
Angle: About 30 degrees in each direction of the front of the remote sensor

NOTES ON THE REMOTE CONTROL
• Do not expose the remote sensor of the T562 to a strong light source such as direct sunlight or

illumination. If you do so, you may not be able to operate the T562 with the remote control.

• Point the remote control at the remote sensor on the T562.
• Do not drop or give the remote control a shock.
• Do not leave the remote control near an extremely hot or humid place.
• Do not spill water or put anything wet on the remote control.
• Do not disassemble the remote control.

30°

30°

23 ft (7m)

T562 IM english 23/7/02 9:42 am Page 7

Identification of Controls