NAD T562 - Manual (Page 22)

22
Good quality sound of 2-Channel Stereo system can be achieved by connecting this DVD player to a receiver equipped with a two analogue audio
inputs (right and left) and speaker system (right and left front speakers).
CONNECTING TO AN ANALOGUE STEREO SYSTEM
Setup
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
From the MIXED AUDIO OUT
(L & R) Jacks
Audio cable
To the analogue input (L & R)
amplifier equipped with
analogue inputs.
TV or monitor with
audio/visual inputs
Audio system
From S-VIDEO / Component Video /
Composite or SCART
S-VIDEO / Component / Composite
75–Ohm coaxial or SCART cable
To S-VIDEO / Component /
Composite or SCART
inputs of the TV.
TO ENJOY GOOD QUALITY SOUND
You need to select from the OSD drop down menu, Audio, Analogue On, and 48K.
NOTES
• Switch the power off on the T562 before switching the SCART/S-VIDEO switch position.
• Refer to the owner’s manual of your receiver as well.
• Before you connect the T562 to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before
making any connections.
• Depending on your Digital sound decoder, the decode rate may be 96 or 48K.
• The output sound of the T562 has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level. Otherwise, the
speakers may be damaged by a sudden high volume sound.
• Turn off the receiver before you connect or disconnect the T562’s power cord. If you leave the receiver power on, the speakers may be damaged.
T562 IM english 23/7/02 9:43 am Page 22