NAD T562 - Manual (Page 20)

20
2 CHANNEL DIGITAL STEREO SOUND
You can enjoy the dynamic sound of 2 Channel Digital Stereo by connecting this DVD player to a receiver equipped with a digital audio input and
speaker system (right and left front speakers).
CONNECTING TO A SURROUND SOUND SYSTEM
Setup
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
TV
From the DIGITAL OUT
(COAXIAL or OPTICAL) jacks
From S-VIDEO /
Component Video /
Composite or SCART
75-Ohm coaxial cable
or optical cable
To the digital input of an amplifier equipped with either
75-Ohm coaxial digital input or digital optical input.
To S-VIDEO / Component /
Composite or SCART
inputs of the TV.
S-VIDEO / Component / Composite
75-Ohm coaxial or SCART cable
TO ENJOY DIGITAL SOUND
You need to select from the OSD drop down menu, Audio, Analogue Off, and Auto, 96K or 48K. If uncertain, select Auto from the Analogue Off
menu. (Refer to Initial Setup Settings, Audio)
NOTES
• Switch the power off on the T562 before switching the SCART/S-VIDEO switch position.
• Refer to the owner’s manual of your receiver as well.
• Before you connect the T562 to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before
making any connections.
• Depending on your Digital sound decoder, the decode rate may be 96 or 48K.
• The output sound of the T562 has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level. Otherwise, the
speakers may be damaged by a sudden high volume sound.
• Turn off the receiver before you connect or disconnect the T562’s power cord. If you leave the receiver power on, the speakers may be damaged.
TV
T562 IM english 23/7/02 9:43 am Page 20