beautypg.com

Rear panel (european version), Identification of controls – NAD T562 User Manual

Page 6

background image

ENGLISH

FRANÇAIS

DEUTSCH

NEDERLANDS

ESP

AÑOL

IT
ALIANO

POR

TUGUÊS

SVENSKA

6

1 DIGITAL OUT COAX Jack
2 DIGITAL OUT OPTICAL (With Dust Protection Cap) Jack
3 MIXED AUDIO OUT (L & R) Jacks
4 S-VIDEO OUT Jack
5 Composite VIDEO OUT Jack
6 COMPONENT VIDEO OUT Jacks

7 VIDEO OUTPUT S-VIDEO-SCART/RGB Switch
8 SCART/RGB OUT Jack
9 12V TRIGGER IN jack
10 AUTO TRIGGER ON-OFF Switch
11 EXT. IR IN Jack
12 Power cord socket

NOTE

Remove the dust protection cap from the connector and connect the optical digital cable (not supplied) firmly so that the configurations of both
the cable and the connector match. Keep the dust protection cap and always reattach the cap when not using the connector to protect against
dust.

NOTE

The 12V TRIGGER IN jack is a 3.5mm monotype miniature phone jack with the centre pin the 12V signal-sense. We recommend that you use a
good quality cable with shield when attaching the 3.5mm monotype plug so as to prevent false triggering of the amplifier due to electro-magnetic
interference from nearby electronic equipment. The 12V-IN TRIGGER allows you to have an external 12V signal to turn ON the NAD T562 from
standby. This 12V signal must be a continuous 12V signal in order to keep the T562 in the ON state. Once you remove the 12V signal the T562
will return to standby. Check the specifications of the trigger input terminal the other components to ensure these are compatible with the T562.
All 12V-TRIGGER inputs and outputs on other NAD components with a 12V-TRIGGER feature are fully compatible with the NAD T562’s 12V-
TRIGGER IN. Before making any connections to any 12V-TRIGGER IN make sure all components are disconnected from the AC mains. If in doubt
over the connections, installation and/or operation of the 12V-TRIGGER IN connection, consult your NAD dealer or sales representative. Failure to
observe the above may result in damage to the NAD T562 and/or any ancillary components attached to it.

NOTE

The EXT. IR IN jack is connected to the output of an IR (infrared) repeater (Xantech or similar), or the IR output of another component to allow
control of the T562 from a remote location. Ask your dealer or custom installer for further details

REAR PANEL (EUROPEAN VERSION)

T562 IM english 23/7/02 9:42 am Page 6

Identification of Controls