NAD T562 - Manual (Page 19)

19
DOLBY PRO LOGIC SURROUND SOUND
One can enjoy the high quality sound of Dolby Pro Logic Surround Sound if your A/V receiver is equipped with a Dolby Pro Logic Surround Sound
processor or decoder.
CONNECTING TO A SURROUND SOUND SYSTEM
Setup
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
TV
From the
MIXED AUDIO L/R jacks
75-Ohm audio cables
From S-VIDEO / Component Video /
Composite or SCART
S-VIDEO / Component / Composite
75–Ohm coaxial or SCART cable
To S-VIDEO / Component / Composite or
SCART inputs of the receiver Connection example To RCA audio input jacks of
the surround sound receiver
equipped with a Dolby Pro
Logic decode r
Front Speaker
(left)
Front speaker
(right) Centre speaker
Rear speaker (left) Rear speaker (right)
To enjoy Dolby Pro Logic sound
from this DVD player you need the
following:
• DVD recorded in Dolby Pro
Logic format.
• Dolby Pro Logic A/V receiver
equipped with a Dolby Pro
Logic decoder, or Dolby Pro
Logic decoder and power
amplifier
• 5 speakers
TV
WITH A RECEIVER EQUIPPED WITH A DOLBY DIGITAL DECODER
Connect the equipment the same way as described in Enjoying Dolby Digital Sound. Refer to that A/V receiver’s owner’s manual and set the receiver
so you can enjoy Dolby Pro Logic Surround sound.
WARNING
Do not set the Digital Audio Output of this DVD player to ‘Analogue Off’ unless you are connecting the DIGITAL OUT jack of this DVD player to
an AV decoder that has the Dolby Digital decoding function. High volume sound may damage your hearing as well as the speakers. (Refer to
Initial Setup Settings, Audio)
NOTE
Refer to the owner’s manual of your audio equipment as well. Depending on your Dolby Digital surround sound decoder, the decode rate may
be 96 or 48K. When you connect the T562 to other equipment, be sure to turn off the power and unplug all of the equipment from the wall
outlet before making any connections. The output sound of the T562 has a wide dynamic range. Be sure to adjust the receiver’s volume to a
moderate listening level. Otherwise, the speakers may be damaged by a sudden high volume sound. Turn off the receiver before you connect or
disconnect the T562’s power cord. If you leave the receiver power on, the speakers may be damaged.
T562 IM english 23/7/02 9:43 am Page 19