Routing frequency output to a terminal, Default counter terminals, Routing frequency output to a terminal -31 – National Instruments NI 6238 User Manual
Page 96: Default counter terminals -31, To the, Default counter, Terminals, Section
Chapter 7
Counters
© National Instruments Corporation
7-31
Routing Frequency Output to a Terminal
You can route Frequency Output to any output PFI <6..9> terminal. All
PFIs are set to high-impedance at startup.
Default Counter Terminals
By default, NI-DAQmx routes the counter/timer inputs and outputs to the
PFI pins, shown in Table 7-4.
You can use these defaults or select other sources and destinations for the
counter/timer signals in NI-DAQmx. Refer to Connecting Counter Signals
in the NI-DAQmx Help or the LabVIEW 8.x Help for more information on
how to connect your signals for common counter measurements and
generations. M Series default PFI lines for counter functions are listed in
Physical Channels in the NI-DAQmx Help or the LabVIEW 8.x Help.
Table 7-4. NI 6238/6239 Device Default NI-DAQmx Counter/Timer Pins
Counter/Timer Signal
Default Pin Number (Name)
Port
CTR 0 SRC
13 (PFI 0)
P0.0
CTR 0 GATE
32 (PFI 1)
P0.1
CTR 0 AUX
33 (PFI 2)
P0.2
CTR 0 OUT
17 (PFI 6)
P1.0
CTR 0 A
13 (PFI 0)
P0.0
CTR 0 Z
32 (PFI 1)
P0.1
CTR 0 B
33 (PFI 2)
P0.2
CTR 1 SRC
15 (PFI 3)
P0.3
CTR 1 GATE
34 (PFI 4)
P0.4
CTR 1 AUX
16 (PFI 5)
P0.5
CTR 1 OUT
36 (PFI 7)
P1.1
CTR 1 A
15 (PFI 3)
P0.3
CTR 1 Z
34 (PFI 4)
P0.4
CTR 1 B
16 (PFI 5)
P0.5