Netopia 6.3 - Manual (Page 108)

108
Appendix A SHELL Commands
The only command you cannot truncate is restart. To prevent accidental inter-
ruption of communications, you must enter the restart command in its
entirety.
You can use the Up and Down arrow keys to scroll backward and forward through
recent commands you have entered. Alternatively, you can use the !! command
to repeat the last command you entered.
Platform Convention
For each Shell and Config command, an “Index Tab” shows which platform(s) the
command supports. For example
Both the Cayman 3220-H and 2E-H platforms use this command.
The Cayman 3220-H platform uses this command.
The Cayman 2E-H platform uses this command.
SHELL Commands
Sends an Address Resolution Protocol (ARP) request to match the
nnn.nnn.nnn.nnn
IP address to an Ethernet hardware address.
Lets you check the ATM connection reachability and network connectivity. This
command sends five Operations, Administration, and Maintenance (OAM) loop-
back calls to the specified vpi/vci destination. There is a five second total timeout
interval.
Use the segment argument to ping a neighbor switch.
Use the end-to-end argument to ping a remote end node
Clears the configuration settings in a Cayman Gateway. If you do not use the
optional yes qualifier, you are prompted to confirm the clear command.
BOTH arp nnn.nnn.nnn.nnn
DSL atmping vpi vci [ segment | end-to-end ]
ENET reset ppp [enet-B]
BOTH arp nnn.nnn.nnn.nnn
DSL atmping vpi vci [ segment | end-to-end ]
BOTH clear [yes]