Niles Audio SW10JM User Manual

Page 26

Text mode
Original mode

2b. Determine suitable wire routing method. The

SW10WM is provided with terminal cups at both
the bottom and top of the unit for convenience.

Preparing the cabinet

3a. Remove the large bolts located at the top of the

cabinet and ﬂip the brackets over re-installing
brackets with the same bolts, leaving them
loose. Ensure the ﬂange surface with 4 holes
is above the cabinet. Allow access for the
installation hardware.

3b. Locate the feet inside the pre-construction

package. Place feet on cabinet.

Installing the cabinet

4. Place subwoofer cabinet into stud bay and

adjust brackets to accommodate the exact width
of construction. Tighten the bolts.

Top

Bottom

(CONTINUED ON NEXT PAGE)