NEC EXPRESS5800 N8800-099F - Manual (Page 134)

6-22 Troubleshooting
Problems with System Repair
“Press F6 if you need to install a third party SCSI or RAID driver…” was not displayed and
there was no chance to enter
F5 and F6 when “When starting Recovery Console from Windows
Server 2003 CD-ROM” was performed.
† Did you press any key when the message “Press any key to boot from CD” is displayed on
top of the screen?
o Start-up from Windows Server 2003 CD-ROM is required to start the Recovery Console
from Windows Server 2003 CD-ROM. Press any key while the message “Press any key
to boot from CD” is displayed on the screen. You cannot start the Recovery Console from
the CD-ROM unless the any key is pressed while the message is being displayed. Restart
the system when it does not start from CD-ROM and the message “Press F6 if you need
to install a third party SCSI or RAID driver…” is not displayed. See “Starting up
Recovery Console” in “SYSTEM REPAIR” in this chapter to start again.
The screen turns out to be black for a while when booting the Recovery Console.
o If you start the Recovery Console that is installed in the system, the screen turns out to be
black for a while when booting the Recovery Console. Since the system is normally
working, please wait for a while.
When the system’s update is being processed, Operating System Stop Error occurred at the
system reboot.
o During the system update process, the message “Windows-FT Orphaning A disk that is
part of a fault–tolerant volume can no longer be accessed” is displayed, and there is
sometimes a case that OS Stop Error occurs on a reboot after this process. See
IMPORTANT of step 6 in “Updating the System” in this chapter when OS Stop Error
occurs, and reboot the system. In addition, the system’s update is successfully being
performed when the message “Windows-FT Orphaning A disk that is part of a
fault-tolerant volume can no longer be accessed” is displayed. However, the mirroring of
HDD is not applied. Make sure to check the hard disk’s mirroring after the system
start-up.