beautypg.com

NEC EXPRESS5800 N8800-099F User Manual

Page 128

background image

6-16 Troubleshooting

Windows can be operated after a setup but each module or PCI board is not duplicated. (FT
Status LED does not light on green).

†

Did you abort the installation during a setup such as by closing a window of the programs that
are running?

o

Installation will be aborted if you finish the programs that are running such as by closing
a window. Although the operation on Windows will be feasible, PCI boards will not be
duplicated properly if you abort the installation. In this case, “Step 1: Things Required
for Setup” needs to be done from the beginning.

DISK Access LED will be lit in amber.

†

Did you properly setup the duplex of HDDs?

o

DISK Access LED will be lit in amber, if a setup for duplex is not performed. (See
“LEDs” in the separate volume of the User’s Guide for details about the indication status
of LED.) See “Step 6: Set Dual Disk Configuration” and set up the duplex of HDDs.

“Complete memory dump” cannot be specified to the write debug information on “Set Memory
Dump” (Debug Information).

o

“Complete memory dump” cannot be specified (not displayed) if the memory size
exceeds 2GB. Specify “Kernel memory dump” in this case.

Cannot find the recommended value for a paging file.

o

See “Size of the Partition to be Created” in “Step 1: Things Required for Setup.”

Cannot specify a network path for the storage location of diagnosis information (collect log) in
“Set Dr. Watson.”

o

You cannot specify a network path. Specify a path to a local computer.

The Telnet Service is not installed.

o

Adjust the computer name to 14 characters or less, and then install the Telnet Service
according to .

1.

Select [Run] from the Start menu.

2.

Type “tlntsvr /service” in the [Open] box, and click [OK].

3.

From the Start menu, point to [Control Panel] and click [Administrative Tools] and
then click [Services] to specify whether the Telnet Service is registered.

Note: Once the installation of Telnet Service is finished, you may change the computer

name to 15 or more characters.

This manual is related to the following products: