Nortel Networks Instant Internet 400 Unit - Manual (Page 45)

Chapter 4 DIP switch settings 45
Setting Up the BayStack Instant Internet 400 Unit
Table 13 shows the switch settings to disable the switch settings for resetting the
password and user-defined configurations .
Table 14 shows the switch settings for restoring your unit to factory default
conditions.
Table 13 Switch settings to disable switch settings for resetting the password
and user-defined configurations
1 2 3 4 5 6 7 8
ON • • • • • •
OFF • •
Table 14 Switch settings for restoring factory default conditions
1 2 3 4 5 6 7 8
ON • • • • • •
OFF • •
Caution: If you use these switch settings to restore your unit to factory
default conditions, the following user-defined settings are removed or
reset: password, hosts, port mappings, unit configuration, access
restrictions, unit registration, and encryption authorization.
If you purchased and installed the 3DES Encryption Module (part number
CQ1010005), you need to reinstall it.
If you used the switch settings in Table 13 to disable the reset password
and configuration switch settings, these settings are re-enabled.