Nortel Networks WAG54G - Manual (Page 16)

9 Chapter 3: Getting to Know the Wireless-G ADSL Gateway
LEDs and Power Button on Side Panel
Wireless-G ADSL Gateway
LEDs and Power Button on Side Panel
The Gateway's LEDs, which indicate network activity, are located on the other side panel. The Gateway’s power
button is also located on this panel.
Press the power button to turn the Gateway on or off when power is available from the power adapter.
The Gateway’s LEDs are described below.
POWER Green. The POWER LED lights up when the Gateway is powered on.
ETHERNET (1-4) Green. The ETHERNET LED serves two purposes. If the LED is continuously lit, the Gateway is
successfully connected to a device through the LAN port. If the LED is flashing, it is an
indication of any network activity.
WIRELESS Green. The WIRELESS LED lights up whenever there is a successful wireless connection. If the
LED is flashing, the Gateway is actively sending or receiving data to or from one of the devices
on the network.
DSL Green. The DSL LED lights up whenever there is a successful DSL connection. The LED blinks
while the Gateway is establishing the ADSL connection.
INTERNET Green/Red. The INTERNET LED lights up green when a connection to your Internet Service
Provider (ISP) is established, and blinks when information is passing through the connection. If
the connection is in bridge-only mode, however, the INTERNET LED does not light up. The
INTERNET LED lights up red when the connection to the ISP fails.
Figure 3-2: Power Button and LEDs on Side Panel