Net Optics Smart Filtering none - Manual (Page 15)

11
*** Confidential - DO NOT Distribute ***
Director
Chapter 2
Installing Director
This chapter describes how to install and connect Director devices. The procedure for installing Director follows these
basic steps:
Plan the installation 1.
Unpack and inspect the Director device 2.
Install the DNM modules 3.
Install the SFP and XFP modules 4.
Rack mount the Director device 5.
Connect power to Director 6.
Connect the command line interface (CLI) RS-232 DB9 port or the Management port 7.
Log into the CLI 8.
Configure Director parameters using the CLI 9.
Connect Director to the network with Span ports and in-line links 10.
Connect the monitoring tools to Director 11.
Configure a Matrix Switch connection in Director 12.
Check the installation 13.
This chapter pertains to installing a single Director. Chapter 4 addresses daisy-chaining up to 10 Director chassis into a
single logical system.