Nautilus BE STRONG EV916 - Manual (Page 36)

C H A N G I N G T H E G A M E I N H E A LT H A N D F I T N E S S ™
34
CONSOLE CODES
[Level: UP] or [Level: DOWN] to scan through
the choices. Select the option you want by
pressing [ENTER].
Error log
To display the machine’s error log, press
[ENTER] when the message, “ERROR LOG”, is
displayed. The console will report various
error messages in the display window. The
total amount of errors will be displayed in the
upper right window. Note that only the highest
priority reported error will be displayed. Errors
are handled in two ways. First, as a non-
fatal “WARNING” which will display the text
message but continue system operation until
you press the [CLEAR] key. The second way is
a fatal “ERROR” which will stop the exercise
and return the system to an idle intensity state.
The console will display the error text and not
let you restart the program unless power has
been turned off and then back on.
Reset service time
To reset the time between service or
maintenance calls, press [ENTER] when
the message, “MAINT HOURS” is displayed.
Selecting this code will reset the maintenance
timer to 0 hours.
3. To exit “DIAGNOSTICS2”, press the
[CLEAR] key.
Confi guration Codes
To change the machine type from Stepper,
StepMill, Bike or Elliptical, press (LEVEL: UP),
(8), (ENTER). The display will read “CHANGE
MACHINE”. Press (ENTER) to display the
list of machines, then press (LEVEL: UP) or
(LEVEL: DOWN) to scan through the choices.
Select the machine type you want by pressing
(ENTER).
CommElliptical_OM_0305.indd 34 6/6/2005 2:22:59 PM