Figure d-9. smb connectors location and pinout, Table d-8. smb connector signals, External smbs – National Instruments 800 Series User Manual
Page 65

Appendix D
Front Panel and Connectors
VXIpc 800 Series User Manual
D-14
© National Instruments Corporation
External SMBs
Figure D-9 shows the location and pinouts for the SMB connectors on
the VXIpc 800. The SMB connectors are used for an external clock
signal and TTL trigger input and output. Table D-8 gives the name and
description for the SMB connector signals. Also see Table D-9 for a
description of the signal characteristics for the SMB connections.
Amp manufactures an SMB mating connector, part number 1-413985-0.
Figure D-9. SMB Connectors Location and Pinout
Table D-8. SMB Connector Signals
Pin
Signal Description
Center
TTL Trigger or Clock Signal
Shield
Ground
Center
SMB
Shield
2
1
See also other documents in the category National Instruments Computer Accessories:
- R Series Intelligent DAQ PXI-784xR (14 pages)
- 7344 (66 pages)
- Relay Module SCC-RLY01 (9 pages)
- Compact FieldPoint Mounting Accessories cFP-21xx (10 pages)
- PCI-4451 (115 pages)
- NI 6239 (172 pages)
- SCXI-1190 (54 pages)
- SCXI-1190/1191 (45 pages)
- NI 785xR (74 pages)
- DIO 6533 (125 pages)
- Multisystem eXtension Interface NI PCIe-836x (37 pages)
- GPIB-BUF (40 pages)
- 6527 (47 pages)
- PCI-8336 (43 pages)
- PXI NI PXI-8105 (73 pages)
- 6025E (136 pages)
- NI 78xxR (12 pages)
- PCI-6110E/6111E (113 pages)
- NI 6115/6120 (127 pages)
- 1128 (97 pages)
- NI 6115 (127 pages)
- NI 784xR (74 pages)
- GPIB-100A (43 pages)
- VXI-MIO Series (151 pages)
- Low-Cost Multifunction I/O Board for ISA Lab-PC+ (211 pages)
- PC-DIO-24/PnP (107 pages)
- PC-LPM-16/PnP (125 pages)
- NI 7831R (71 pages)
- 653X (147 pages)
- VXI/VME 600 (61 pages)
- PXI NI PXI-1052 (70 pages)
- PC-DIO-96 (105 pages)
- NI UES-3880 (14 pages)
- GPIB-COM (56 pages)
- Switch Executive (8 pages)
- AT-MIO-16X (330 pages)
- 7340 PCI (67 pages)
- NI 783xR (73 pages)
- NI CVS-1450 Series (91 pages)
- SCXI-1321 (16 pages)