Ibbna – National Instruments GPIB-PC User Manual
Page 91

BASICA/QuickBASIC GPIB-PC Function Calls
Section Four A
GPIB-PC User Manual
4A-16
©National Instruments Corp.
BASICA/QuickBASIC
BASICA/QuickBASIC
IBBNA
IBBNA
Purpose:
Change access board of device
Format:
CALL IBBNA (BD%,BNAME$)
Remarks:
BD%
specifies a device.
BNAME$
specifies the new access
board to be used in all device calls to that device.
IBBNA
is needed only to alter the board assignment from its
configuration setting.
The
IBBNA
function identifies the board that will be used
in subsequent device functions to access the specified
device.
IBBNA
permits you to alter the association of
devices and interface boards from the settings originally
configured with the configuration program.
The assignment made by this function remains in effect
until
IBBNA
is called again, the
IBONL
or
IBFIND
function is called, or the system is rebooted. The original
configuration established with the configuration program is
not permanently changed.
Refer also to Table 2.1.
Device Example:
1.
Associate the device
DVM%
with the interface board
"GPIB0"
.
100 REM DVM is a name assigned using
110 REM IBCONF.
120 REM (GPIB0 is a factory default board
130 REM name which cannot be changed).
140 BDNAME$ = "DVM"
150 CALL IBFIND (BDNAME$,DVM%)
160 REM This call to IBBNA establishes
170 REM GPIB0 as the access board for the
180 REM device DVM%.
190 BNAME$ = "GPIB0"
200 CALL IBBNA (DVM%,BNAME$)