beautypg.com

Section two - installation and configuration, Installing the hardware, The gpib-pc software package – National Instruments GPIB-PC User Manual

Page 26

background image

©National Instruments Corp.

2-1

GPIB-PC User Manual

Section Two - Installation and
Configuration

The procedures for installing your GPIB-PC depend on your model of
board and your make of computer. A supplement to Section Two
contains information about your interface board. Section Two A, for
example, contains information about the model GPIB-PCIIA for the IBM
PC and compatible computers.

Installing the Hardware

To install your hardware, follow the instructions in the Section Two
supplement for your interface board.

If you change the default settings of any switches, make a note of the
new values so that you can refer to them when you configure your
software.

Install the hardware before continuing.

The GPIB-PC Software Package

Before you install your software, you might wish to review the files on
your GPIB-PC distribution diskette to gain an understanding of what
they are.

The following files are the main files of the GPIB-PC software:

GPIB.COM

- is a device handler file that is loaded at system

start-up by the DOS operating system. Handler is a term used
by National Instruments to refer to a loadable device driver.

BIB.M

- is a language interface file that provides an

application program access to the GPIB-PC handler.

BIB.M

is

intended for use with programs written in BASICA.

QBIB*.OBJ

- is a language interface file that provides an

application program access to the GPIB-PC handler.

QBIB*.OBJ

is intended for use with programs written in

QuickBASIC.