Nikon DSR-1500AP - Manual (Page 68)

68
Menu Contents
C
h
ap
te
r 4
M
e
nu
S
e
tti
n
gs
JOG CONTROL [> Jog ctrl]: Select whether to adjust the
audio playback speed during slow playback.
OFF [>> OFF]: Do not adjust the audio playback speed.
*
ON [>> ON]: Adjust the audio playback speed.
SHUTTLE MUTE [> Shutl mute]: Set the audio muting
conditions during shuttle playback.
* OFF [>> OFF]: Not muted.
CUEUP or PREROLL [>> CUEUP]: Muted during cue-up or
preroll operations.
FULL [>> FULL]: Muted in shuttle mode.
AUDIO EDIT [> Audio edit]: Specify the type of editing for
audio signals.
* CUT EDIT [>> Cut edit]: Cut editing (Discontinuity in audio
signal may result at the editing point, causing noise during
playback.)
FADE IN/OUT [>> Fade]: Fade in and fade out
DV PB ATT [> DV PB ATT]: When playing back a tape
recorded in consumer DV format, select whether to
attenuate the audio output level.
OFF [>> OFF]: Do not attenuate.
*ON [>> ON]: Attenuate.
Note
This setting is valid only when the recording format setting is
DVCAM. This is not valid for DV format.
INTERFACE SELECT [Interface]: Settings related to
external interfaces Description of settings
VIDEO OUTPUT [> Video Out]: Select the format of analog
video signals to be output from the three VIDEO OUT
connectors (Y/CPST, R
−Y/C/CPST, and B−Y/CPST
(SUPER)).
Note
When this menu item is set to Y −R, B, the B−Y/CPST (SUPER)
connector outputs the B −Y signal. In this case, changing the
setting of an internal switch allows the text data for
superimposition on the monitor screen to be output from the
right-hand REF. VIDEO IN connector (marked
). For more
information about this, consult your Sony dealer.
*COMPOSITE [>> Composite]: Composite video signals
S-VIDEO [>> S-Video]: S-video (separated Y and C) and
composite video signals
Y–R, B [>> Y–R, B]: Y, R −Y and B−Y component video
signals
DIGITAL OUTPUT [> Digit Out]: Select the format of signals
to be output from the SDI/SDTI (QSDI) OUT1/OUT2
connectors (optional DSBK-1501 board required).
*SDI [>> SDI]: SDI format
SDTI [>> SDTI]: SDTI (QSDI) format
AUDIO OUTPUT [> Audio Out]: Select the channels for audio
output from the AUDIO OUT 1/3 and 2/4 connectors.
*1/2 CH [>> 1/2CH]: Output channel 1 to the AUDIO OUT 1/3
connector and channel 2 to the AUDIO OUT 2/4
connector.
3/4 CH [>> 3/4CH]: Output channel 3 to the AUDIO OUT 1/3
connector and channel 4 to the AUDIO OUT 2/4
connector.
REMOTE I/F [> Remote I/F]: When remote-controlling this unit
with the LOCAL/REMOTE switch set to REMOTE, select
either the REMOTE connector or i.DV IN/OUT connector
(optional DSBK-1501 board required) for connecting a
remote control unit.
*9PIN [>> 9PIN]: Remote-control via the REMOTE connector.
i.LINK [>> i.LINK]: Remote-control via the i.DV IN/OUT
connector.
AUDIO CONTROL [Audio]: Settings related to audio
control Description of settings
IN OUT