Nikon DSR-1500AP - Manual (Page 37)

37
Playback
C
h
apt
er 2
Rec
o
rding
a
nd Pla
y
b
a
c
k
Repeat Playback—Automatic Cyclical Playback
Proceed as follows to perform automatic cyclical playback of recording (repeat
playback) between selected start and end points.
1
Set the desired repeat start and end points with the REPEAT FUNCTION
menu item (see page 59).
You can set points A and B as start and end points by following the
procedure described in the next section.
2
Set the REPEAT MODE menu item (see page 59) to ON.
The REPEAT indicator lights.
3
Press the SET (YES) button to save the new setting and close the menu.
4
Press the PLAY button.
The unit repeats playback between the repeat start and end points set in step
1.
Setting Points A and B for Repeat Playback
You can set the repeat playback start point (point A) and end point (point B) by
using the current tape position or inputting time code values.
To perform repeat playback after setting points A and B, press the PLAY button
when the REMOTE indicator is off. When the DSRM-10 Remote Control Unit
is connected to the CONTROL S connector on the front panel, you can also start
repeat playback by pressing its PLAY button with the REMOTE indicator of
this unit off.
Note
When performing repeat playback using points A and B as the playback start
and end points, make sure that the REPEAT TOP and REPEAT END menu
items (see page 59) are set to A POINT and B POINT, respectively.