Nikon DSR-1500AP - Manual (Page 38)

38
Playback
C
h
apt
er 2
Rec
o
rding
a
nd Pla
y
b
a
c
k
Setting the current tape position as point A or B
Proceed as follows to set the current tape position as point A or B for repeat
playback.
While holding down the SET (YES) button in the menu control section, press
the g or G button. The time code value of the current tape position is set as point
A or B, and a message “A set” or “B set” is displayed for 0.5 second in the time
counter display.
Once set, the point A or B time code value is held in the non-volatile memory
of the unit until changed. It is not lost when the unit is powered off.
Note
When setting point A or B, you can only use a time code value. Even when
COUNTER is selected with the COUNTER SELECT button, you cannot use a
CNT value to set point A or B.
To check the point A or B time code value
Press the g or G button in the menu control section. While the button is held
down, the point A or B time code value is displayed on the monitor and in the
time counter display.
If you hold down the g and G buttons simultaneously, the value shown is the
point B time code value minus the point A time code value. If the point A time
code value is greater than the point B time code value, a minus sign (
−) is shown
before the value.
REW PLAY F FWD STOP REC
INPUT VIDEO AUDIO V:SDTI SDTI i.LINK SDI SG SDI SG SDI SG
ANALOG CH-1 1/2
AES/EBU
dB 0
-12 -20
-30
-40
-60
OVER
2 4 CH-
dB 0
-12 -20
-30
-40
-60
OVER
1 3 CH-
OUTPUT VIDEO AUDIO HOURS MINUTES SECONDS FRAMES SDI SDTI COMPOSITE S VIDEO Y-R,B
COMPOSITE S VIDEO Y-R,B
CH 1/2
CH 3/4 PB FS 48K 44.1K 32K
U-BIT TC NO
CL
EDIT
REC INHI
REPEAT COUNTER SERVO
REC MODE 2CH 4CH VITC EDIT MODE REMOTE 9P i.LINK
ANALOG CH-2 3/4
AES/EBU
MENU RESET(NO)
SET(YES)
TC
PRESET
Buttons used for setting
the current tape position
as point B
Buttons used for setting
the current tape position
as point A