Niles Audio ZR-4 User Manual

Page 26

NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373

2. Press

9 7 6

. The Source Key LED blinks twice

3. Press a Source key twice (i.e., TV. VCR/DVD, CBL/ SAT,

etc.) to clear all the learned keys for that device. The
Source Key LED blinks twice and the R-6L exits from
programming mode.

RESTORING ALL KEY FUNCTIONS TO

FACTORY SETTINGS

1. Press and hold

SETUP until a Source Key LED blinks

twice, then release.

2. Enter

9 8 0. The LED blinks four times.

3. Press and hold

SETUP

until the red LED blinks twice,

then release.

PROGRAMMING A SEQUENCE

Your Niles

R-6L Hand-Held Learning Remote Control includes

the ability to program any key (other than the

SETUP

key) with

a Sequence function. Each key can be set up to perform a pre-
programmed set of sequential commands with the press of one
key. A sequence can be used to control a home theater operation,
to set a favorite channel, or for other multiple functions you would
like to control with one key press. Moreover, each Key can hold a
sequence of up to 15 commands.

NOTE: PROGRAMMING A NEW SEQUENCE OVER AN EXISTING ONE ERASES
THE ORIGINAL SEQUENCE.

PROGRAMMING A DEVICE-DEPENDENT

SEQUENCE

1. Press a Source key.

2. Press and hold

SETUP until the Source key LED blinks

twice, then release.

3. Press

9 7 8. The Source key LED blinks twice.

4. Press the key to which you wish to assign a sequence.

5. Enter the series of commands (Key Presets) you want the

sequence to execute (up to 15 commands).

6. Press and hold

SETUP until the Source Key LED blinks

twice, then release.

Now, when you press the sequence key, the remote sends the series
of commands you have entered, but only if the device you selected in
step 1 is selected. For example, you could program the sequence key
to turn on both your TV and cable box and select a particular channel,
but only if TV is selected. If DVD is selected, this key does not execute
the sequence you set up for the TV. To clear the sequence, repeat
steps 1-6 above, but do not enter a series of commands at step 5.

PLAY THE AM/FM TUNER

1. Press the

Tuner key on any zone Keypad or the R-6L

Remote Control and the zone will turn on to the preset

start volume as well as the last selected station.

2. The 12V out on the rear panel of the ZR-4 MultiZone

Receiver and the Keypad in that zone will become active.

3. Pressing the

Tuner button will toggle through the preset

stations in the ZR-4’s memory. If no presets are stored

then the tuner will scan to the next station.

4. Additional control over the tuner’s functions is available

using the R-6L Remote Control.

Volume + and Volume – will raise and lower the level of

sound in the zone.

6. Pressing the

Off key will turn off the zone. The 12V

output on the keypad become inactive. The 12V output

on the rear panel becomes inactive if all other zones
are off.

OPERATING THE ZR-4