National Instruments NI CardBus-8310-to-PXI Expansion - Manual (Page 16)

Chapter 2 Hardware and Software Installation
NI CardBus-8310-to-PXI Expansion User Manual 2-2 ni.com
Windows 2000/XP (Without XP Service Pack 2)
1. If you do not have your system configured to allow autorun CDs, you
must run
SETUP.EXE to install the NI CardBus-8310 driver.
2. Follow the prompts to install the software.
3. When the software prompts you reboot, do so. When the system has
been rebooted, the installation process is complete.
Windows XP (With Service Pack 2)
1. If you do not have your system configured to allow autorun CDs, you
must run
SETUP.EXE to install the NI CardBus-8310 driver.
After the software setup utility launches, the dialog box shown in
Figure 2-1 will appear.
Figure 2-1. Software Installation Dialog Box
2. The driver will make a small change to boot.ini , and then prompt
you to reboot, as shown in Figure 2-2. You must do this before the
driver install can continue.