Pitney Bowes ADDRESSRIGHT DA300 - Manual (Page 5)

5
• Removing the Cartridge
1. With the printer on, press the On Line key
until the display reads OFF LINE.
2. Open the back cover of the printer.
3. Press the Cartridge key on the control panel.
This moves the carriage to the middle of the
printer.
4. To remove the ink jet cartridge, hold the
green cartridge top while placing your thumb
on the cartridge cradle.
5. Pull the cartridge top toward you until the
cartridge pops loose, then lift the print
cartridge out of the cradle as shown.
1. Before you can use your printer with your computer, you must install the Pitney Bowes
DA300 printer driver. The driver gives your computer information about the printer you're
using, and tells the printer about the settings you want to use in your print job. Refer to the
installation instructions with the Envelope Designer
TM Plus CD and the DA300 Operator
Guide for more information.
2. You can design your envelope using the printer’s menu commands, the DA300 print driver,
or Pitney Bowes Envelope Designer™Plus, an easy-to-use program that helps you create
professional-looking envelope layouts quickly. With Envelope Designer™Plus you can
create and position a mailing address, return address, single-line message, barcode and
graphics. Envelope Designer™Plus has an extensive online help system and a Wizard that
guides you through the entire design process. Envelope Designer™Plus virtually eliminates
the need for setting up your envelope manually, using either the print driver options or the
printer's control panel menu options. Envelope Designer™Plus also has online help to guide
you through all available options. To install this handy application, refer to the installation
instructions with the Envelope Designer
TM Plus CD or the DA300 Operator Guide.
Install the DA300 Print Driver and Envelope Designer TM Plus application
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Replacing the Ink Cartridge
• Replacing the Cartridge
1. Remove the cartridge from its shipping
container by peeling the top cover off. Be
careful not to touch the copper ribbon.
WARNING! The ink in the cartridge may be
harmful if swallowed. Keep new and used
cartridges out of reach of children. Discard
empty cartridges immediately.
2. Carefully remove the tape covering the ink
nozzles on the print cartridge. Be careful not
to touch the copper nozzles.
3. Gently insert the cartridge into the carriage at
about a 45 degree angle with the green arrow
on the cartridge top pointing toward the
inside of the printer.
4. Push the cartridge back in the direction of
the arrow until it snaps into place.
10