Pioneer RCS-LX60D - Manual (Page 81)

Recording 06
81
En
Using the built-in A.TV and D.TV tuners
Switching between A.TV and D.TV tuners
• Press to switch between D.TV (digital) and
A.TV (analog).
Changing channels
There are a number of ways to select analog and digital
TV channels. 1 Note that you can’t change the TV channel
during playback, recording or during recording standby.
• Smart Jog
• Number buttons
For example, to select channel 4 (digital channel
D004), press
4 then ENTER ; for channel 34 (digital
channel D034), press 3 , 4 , ENTER . 2
• CH +/– buttons on the front panel.
• For D.TV channels only, you can also use the Channel
List — see below.
Tip
• When changing terrestrial digital broadcast
channels, channels with a low signal strength may
result in a black screen being displayed.
• For other channels, it may take a short while for the
channel picture to appear, and/or for the channel
number to appear.
• In both of the above cases, some improvement may
be possible by adjusting the antenna.
Using the D.TV Channel List
When in D.TV mode, you can call up the on-screen Channel
List anytime by pressing
ENTER . Use the / buttons to
select a channel, then press ENTER to switch to that channel. 3
Displaying a channel banner
A channel banner shows programme titles, start and end
times of the current programme and other channel
information. The information is updated every minute.
• Press to display the channel banner for the
current channel.
• Use the / buttons to display the channel banner
for other channels. To switch to the displayed
banner’s channel, press
ENTER .
• The channel banner displays the Subtitles ( ) and
Teletext/MHEG ( ) icon if they apply to the selected
channel. 4
• To see more detailed channel information, press
INFO again. 5
Use the / buttons to display information about
previous and following programmes. Use the /
buttons to see information about other channels.
• If there is still more information to be displayed,
More ... is displayed; press the BLUE button to see
the extra information.
• To hide the channel banner, press RETURN/EXIT .
Note
1 • If you select a locked channel, you will need to enter your password to access it.
• While listening to D.TV radio channels, the screen saver automatically starts after no button has been pressed for three minutes.
2 Analog channel presets are numbered 1 to 99; digital channel presets are numbered D001 to D999.
A.TV/D.TV
CHANNEL
CHANNEL
SETUP
F.S.SURR
ADVANCED
TEST TONE
SR+ /TUNE+
ENTER
/TUNE–
/ST– /ST+
1 2 3
4 5 6
7 8
0
9
3 • If you select a locked channel, you will need to enter your password to access it.
• While listening to D.TV radio channels, the screen saver automatically starts after no button has been pressed for three minutes.
4 Due to inaccurate information provided by the broadcaster, some icons may occasionally be present or absent in error.
5 Not all channels supply more detailed information.
D001
D002
D003
D004
************
************
******
************
D005
D006
****
******
INFO
Wed.30.Apr 12:46
Now
D001 ************
Next
********************
************* 12:00
12:30
11:30
12:00
-
-
Now ************************
More...
12:00 11:30 -
DVRLX60D_WV_EN.book 81 ページ ２００７年４月２４日 火曜日 午後７時５８分