Pioneer RCS-LX60D - Manual (Page 12)

Connecting up 02
12
En
5 Connect each speaker.
• The front and surround speaker cables have a color-
coded connector at one end and two bare wires at the
other end.
• Since there is only one terminal to connect the two
center speakers, you will need to use the supplied Y-
cable for the connection.
• Twist and pull off the protective shields on each wire.
• Connect the wires to the speaker. Each speaker in the
illustration can be identified by means of the color-
coded indicator provided on the rear-surface model
label. Match the color-coded wire with the color
indicator on the model label, then insert the color-
coded wire into the red (
+ ) side and the other wire
into the black ( – ) side.
• When connecting the center speakers, connect the Y-
cable dual end to the two center speakers in the
same way.
• Connect the other end to the color-coded speaker
terminals on the rear of the receiver subwoofer. Make
sure to insert completely.
The small lug at the wire-end of the speaker plug
should face up or down depending on whether it’s
being plugged into one of the upper or lower speaker
terminals. Please make sure to connect correctly.
MCACC SETUP MIC
SYSTEM CONNECTOR
AC IN
CONTROL IN
USE ONLY WITH DISPLAY UNIT. SEE INSTRUCTION MANUAL.
CONTROL OUT SUBWOOFER
CENTER FRONT
SURROUND
DVD/DVR1 (COAXIAL) DVD/DVR2 (OPTICAL) DIGITAL (OPTICAL) SPEAKERS
DIGITAL AUDIO INPUT
ANALOG
AM LOOP ANTENNA
ANTENNA
FM UNBAL 75
R L
R L
R
L
8
To AC outlet
Y-cable
Receiver subwoofer (SX-LX60D)
6
5
Speaker system (SSP-LX60D)
Front right
(Red)
Center
(Green)
Surround right
(Gray)
Front left
(White)
Center
(Green)
Surround left
(Blue)
Listening position
Color-coded wire
(Connect to speaker)
Color-coded connector
(Connect to rear panel)
Y-cable
To Receiver subwoofer
Upper terminal Lower terminal
RCS-LX60D_WV.book 12 ページ ２００７年４月２４日 火曜日 午後７時５７分