Philips DSR2010 User Manual
Page 42
E
n
g
lis
h
42 SETTINGS
• Channels lists: select RESET to replace all channel lists,
VIRGIN to reset the receiver to the factory settings by
pressing the red colour key, and then launch first
installation, or NO CHANGE to keep your channel lists
as they are.
Note: in the latter case, you will need to use the Channel
Manager feature to add channels to your lists from the
updated channel pool.
- Press
11.6.4 Search for new channels
- Check for adequate signal strength and quality for each
LNB/satellite.
Note: to display the signal strength and quality for a particular
satellite, scroll to the corresponding LNB.
- If necessary, change the pointing of your antenna(s) so as
to maximize the level of the signal quality and strength
bargraph indicators, then fasten your antenna(s) according
to the antenna user manual instructions.
Note: to enable the audible signal quality indicator, press the
yellow colour key.
- Press
Installation screen appears.
During the scanning process, the following information is
reported on screen:
o the number of TV and Radio channels found,
o the scanning progress, indicated as a percentage,
o the strength of the signal and the quality of reception.
Note: if you press
the scanning and return to the Antenna Configuration screen. In
this case, none of the channels found are stored.
When scanning has been successfully completed, a
completion message is displayed as well as the number of
channels detected.
- Press
the main channel list.
DSR2011_052005 17/05/05 14:52 Page 42