Pioneer DVR-550HX-S - Manual (Page 75)

Playback
75
En
08
Playing CDs and WMA/MP3 discs
The table below shows the basic playback
controls for audio CDs 1 , and WMA/MP3
files.
Playing Video CD/Super VCDs
The table below shows the basic playback
controls for Video CD/Super VCDs.
Some discs feature Playback Control (PBC
for short) menus. These discs show PBC in
the display when you load them and display
a menu on-screen from where you can select
what to watch. 2
Press to skip to previous/next
chapter/title. (During playback
you can also use the front panel
CH +/– buttons.)
During playback, enter a title
number then press
ENTER to
skip directly to that title.
Press
CLEAR to clear a number
entry and start again.
(Commercial back/skip)
Turn the
Smart Jog counter-
clockwise for backward skip;
turn clockwise for forward skip.
You can search up to two hours
in either direction.
While paused, press and hold
to start slow-motion playback.
Press repeatedly to change the
playback speed.
While paused, press to advance
a single frame in either direc-
tion. You can also execute
frame-by-frame playback/back-
ward scanning via the
Smart Jog .
Note
1 If you want to play a DTS audio CD, make sure the recorder is connected to a DTS-compatible amp/receiver with
a digital connection. Noise will be output through the analog outputs. Also make sure that STEREO is selected
using the AUDIO button (see Switching audio channels on page 82).
Press to start playback.
Press to stop playback.
Pauses playback, or restarts
playback when paused.
PREV NEXT
CLEAR CLEAR
ENTER
CM SKIP
CM BACK
/ /
STOP
PAUSE
Except WMA: Press to start
scanning. Press again to
increase the scanning speed.
(There are two scan speeds; the
current scan speed is shown
on-screen.)
Press to skip to previous/next
track (or folder for WMA/MP3
disc). (During playback you can
also use the front panel
CH +/–
buttons.)
During playback, enter a track
number then press
ENTER to
skip directly to that track.
Press
CLEAR to clear a number
entry and start again.
Press to start playback.
Video CD only: If RESUME is dis-
played on-screen, playback
starts from the place last
stopped.
Press to stop playback.
Video CD only: You can resume
playback from the same point
by pressing
PLAY . (Press
STOP again to cancel the
resume function.)
2 When playing in PBC mode, some playback features, such as search, repeat and programme play are not
available. You can play a PBC Video CD/Super VCD in non-PBC mode by starting playback using the Disc
Navigator (see
Using the Disc Navigator with playback-only discs on page 78).
PREV NEXT
CLEAR CLEAR
ENTER
STOP
DVR550HXS_WV_EN.book 75 ページ ２００７年３月３０日 金曜日 午前１０時４８分