Hints on installation, Moving the recorder, Resetting the recorder – Pioneer DVR-550HX-S User Manual
Page 152: Additional information 17
Additional information
17
152
En
Hints on installation
We want you to enjoy using this unit for
years to come, so please bear in mind the
following points when choosing a suitable
location for it:
Do...
Use in a well-ventilated room.
Place on a solid, flat, level surface, such
as a table, shelf or stereo rack.
Don’t...
Use in a place exposed to high
temperatures or humidity, including near
radiators and other heat-generating
appliances.
Place on a window sill or other place
where the recorder will be exposed to direct
sunlight.
Use in a dusty or damp environment or
in a room where it will be exposed to
excessive cigarette smoke.
Place directly on top of an amplifier, or
other component in your stereo system that
becomes hot in use.
Use near a television or monitor as you
may experience interference — especially if
the television uses an indoor antenna.
Use in a kitchen or other room where the
recorder may be exposed to smoke or steam.
Use on a thick rug or carpet, or cover
with cloth — this may prevent proper cooling
of the unit.
Place on an unstable surface, or one that
is not large enough to support all four of the
unit’s feet.
Moving the recorder
If you need to move the recorder, first
remove the disc, if loaded, and close the disc
tray. Next, press
STANDBY/ON
to switch
the power to standby, checking that the
POWER OFF
indication in the display goes
off. Wait at least two minutes. Lastly,
disconnect the power cord. Never lift or
move the unit during playback or recording
— discs rotate at a high speed and may be
damaged.
Resetting the recorder
If you need to, you can reset the recorder to
all its factory settings.
1
Make sure that the recorder is on.
2
Using the front panel controls, press
and hold
(Stop) and press
STANDBY/
ON.
The recorder turns off with all settings reset.
DVR550HXS_WV_EN.book 152 ページ 2007年3月30日 金曜日 午前10時48分