Pioneer DVR-550HX-S - Manual (Page 29)

Getting started
29
En
04
Chapter 4
Getting started
Switching on and setting up
When you switch the recorder on for the first
time, you can make several basic settings
using the Setup Navigator feature. This takes
you through setting the clock, the internal TV
tuner and the video output.
If you’re using the recorder for the first time,
we strongly recommend you use the Setup
Navigator before starting to use the
recorder.
1 Switch on your TV and set the video
input to this recorder.
2 Switch on the recorder.
When you switch on for the first time, your
TV should display the Setup Navigator
screen (If the Setup Navigator doesn’t
appear, you can also access it from the
Initial Setup menu; see page 122).
• If this recorder is connected to a
compatible TV using a fully-wired 21-pin
SCART cable, the recorder will take a few
seconds to download country, TV screen
size and language information. (Check
the manual that came with your TV for
compatibility information.)
3 Choose a language (then
press ENTER).
4 Start the Setup Navigator.
• If you don’t want to use the Setup
Navigator, press to select Cancel ,
then press ENTER to exit the Setup
Navigator.
5 Select an Aerial Power
setting
1
for the built-in digital tuner.
• On : power is always supplied to the
connected aerial, whether the recorder
is on or in standby.
• Auto : power is only supplied when this
recorder is on.
• Off : power is never supplied to the
aerial.
6 Select ‘Auto Scan’ to start
scanning for D.TV channels.
• Select Do not set if you want to skip
D.TV channel setup (because they have
already been set up, for example), then
skip to step
8 below.
7 Select your country.
The recorder starts scanning for new
channels. After the scan is complete the
recorder will let you know how many new
channels were found.
• The country setting will apply to both the
digital and analog TV tuners.
STANDBY/ON
ENTER
Initial Setup
Basic
Tuner
Video In/ O ut
A udio In
A udio O ut
Language
Re co rding
Playback
Clock Setting
Input Line Syst em
Pow er Save
HELPp
Setup N avig at or Setup N avig at or
Language Basic
Note
1 If the recorder does not accept the On or Auto setting (the highlight jumps back to Off ), check that the antenna
is properly connected and that it is not shorted, then try making the setting again.
ENTER
k Setting
t Line System
er Save
P
p Navigator p Navigator
Start
Cancel
Start
Complete this setup before you
start using your recorder.
Please use the Initial Setup if you
want to make more detailed settings.
ENTER
ENTER
ENTER
DVR550HXS_WV_EN.book 29 ページ ２００７年３月３０日 金曜日 午前１０時４８分