Philips CF-30FTSAZAM - Manual (Page 56)

7-35
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
HDD Damper Ass'y
Make sure the product with black
sheet on the yellow sponge.
HDD Set Insert after removing the Release Paper of the two-sided tape.
Fold the FPC from the board edge.
HDD Ass'y
Remove the Release Paper on
the back, close and attach it.
Attach it to HDD closely not to loosen.
Push and bend
Do not place the damper
over the plate of FPC.
Do not place the damper
over the plate of heater.
Longer Direction
Sheet
HDD Thermal Plate
1
3
1
2
1
3
0
1
1 3 1 3
Attach the HDD Cushion (Yelllow)
Attach the HDD Cushion (Yelllow)
Attach the HDD Cushion
(Black)
Attach the HDD
Thermal Plate
HDD Cushion (Black)
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Prepare the metal plate bend.
Do not bend it at a sharp
angle to put natural R.
To the level of attaching
closely in this range
When attaching HDD Cushion (Yellow) and HDD Cushion (Black),
set the bending part of the metal plate up.
Metal Plate