Philips CF-30FTSAZAM - Manual (Page 35)

7-14
■ Preparation of Inverter
■ Assembly of LCD Unit
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
2. When handling Inverter-PCB, do not bend or add impact.
S2
N0GF1J000009(without T.S.)
Check the Part No.
N0GF1J000009
N0GF2J000002
Check the Part No.
HBL-0361
Board attachment
Inverter is set,
attach
Match the board edge and the case edge.
Difference: 0.5mm or less
Inverter Shield Case
Prepare Inverter and the Inverter
shield case outside for assysite.
Inverter Shield Case Outside
Inverter Shield Case is set
Attach it putting the protrusion mark next to the caution label.
Wrap Inverter Shield Tape around Inverter
Shield Case and attach.
Ensure that Inverter Shield Tape does not
run over the edge of Inverter Shield Case.
Protorusion by wrinkles, etc. = 0.2 or less
Air Bubble = 1 cm 2 or less / 1 bubble size
Attach the Inverter Shield Tape
Attach the Inverter MIL Shierd
0 0.5mm
LCD Front Ass'y
LCD Drop Holder Insertion
LCD Drop Holder Insertion
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Confirm that the LCD
Cushion is not wrapped.
Match to the LCD
edge and attach it.
Clearance : 2 mm or less