Setting the usb pcb and antenna pcb – Philips CF-30FTSAZAM User Manual
Page 48
7-27
7.2.13.
Setting the USB PCB and Antenna PCB
1. Open the Connector Cover.
2. Fix the Antenna PCB using the 2 Screws.
3. Connect the 2 white Cables.
4. Fix the USB PCB using the Screws.
5. Connect the Cable to the Connector. (CN100)
6. Attach the Tape.
Screws
Screws
FPC
The attention of folding : Breakage countermeasure.
1,The bending inside is R0.5 1
2,Don't mistake a bending direction.
Don't use a mistaken thing.
(R0.5 1)
NG
OK
Figure seen from direction of arrow of A
The terminal of the antenna
cable must not come in
contact with this terminal.
(Put it on the metal fittings
side. )
Cable
Relay Circuit Board Ass'y
Insert FPC into Relay Circuit Board Ass'ys socket
FPC
Mountain Fold (Straight Line)
Valley Fold (Dotted Line)
Insert the Plug
into the Socket
Lock after FPC insertion
FIG
FPC
A
USB PCB
Connector
(CN100)
Antenna PCB
Connector Cover
Antenna Cable
(White)
Antenna Cable
(White)
Tape