Philips CF-30FTSAZAM - Manual (Page 49)

7-28
■ Assembly of USB PCB
Tighten of
Screw
Tighten of
Screw
Tighten of Screw
EXT Antenna PCB
is set
W-LAN Cable
Connection
Safety Working
Safety Working
Attach the Tape Attach the Antenna Cable Sheet
Antenna Cable
Plate is set Order of fixing
Screw Screw
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Connect the coaxial cable from LCD.
Set on the top.
Process the cable from LCD.
Fit to the groove.
Difference : 1 or less
Along the groove
Pull W-LAN Cable out to the surface from the hole.
CAUTION
S1:Insulation S2:Pinching Cables S3:Sharp Edge
S4:Part No. Check S5:Others
S2 S2
Safety Working
Cable USB is set
PCB USB Sub is set
Tighten of Screw
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Match to the CN edge.
Difference: less than 1
Match to the board edge.
Difference: less than 1
Attach the kapton tape into CD Edge Sheet.
S1