Philips CF-30FTSAZAM - Manual (Page 39)

7-18
■ Assembly of Power SW
12 2
25 2
10 1
3 5
Attach the Battery Cushion
Attach the DC Gasket
Tighten of Screw
Power SW LED
Panel is set
FPC Power SW is set
Safety Working
Attach the TP
FPC Tape
Cable Power
Connection
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Battery Pack Insertion Slot
Attach the Battery Slide Sheet (on Battery Cushion)
Avoid air leaking into it. Avoid coming off 4 corners.
Fit to the line.
Ensure the upper and lower Flex holes match.
CAB Wall
Connection Direction
Connection Direction
Top
Bottom
Match the Cabinet slit
and the tape slit.
Do not run the Cabinet
edge out of the tape slit.
CAUTION
S1:Insulation S2:Pinching Cables S3:Sharp Edge
S4:Part No. Check S5:Others
S3