4 static route configuration – Planet Technology WGS3-404 User Manual

Page 204

WGS3 Layer 3 Switch User’s Manual

- 196 -

5.7.5.4 Static Route Configuration

This switch can be configured to dynamically learn the routes to other IP networks, subnets or hosts

using unicast or multicast routing protocols. If the route to a specific destination cannot be learned via

these protocols, or you wish to restrict the path used for transmitting traffic to a destination, it can be

statically configured using the Static Route Table.

Before defining a static route, remember that you must first configure at least one IP interface on this

switch(See