Printek 8000 - Manual (Page 20)

G E T T I N G S T A R T E D
14
Note: The left tractor position is not adjustable. If it is necessary to
adjust where printing begins, refer to “Aligning Print” in the
“Daily Operation” section of this manual.
5. Now position the paper in the right tractor in the same fashion. If
necessary, the position of the right tractor may be adjusted. To do
so, move the lever on the side of the tractor down to unlock the
tractor and slide the tractor sideways on the shafts. If necessary, the
paper guides between the tractors may be slid in either direction to
accommodate the form width. Make sure that the guides are spaced
evenly between the tractors.
After the paper is placed in the tractor and the door is closed, position
the tractor far enough to the right so that there is no buckle in the
paper between the tractors, but not so tight that the holes in the paper
are distorted. Lock the tractor in place by returning the lever to the
up position.
6. Close the paper door.
7. Press the LOAD button.
8. Place the printer on line by pressing the ONLINE button.
FormsMaster 8003 TriTrak™ Model
The following instructions will guide you through loading all three tractor
paths.
1. Make sure the printer is powered on and that the printer is off line
(ONLINE indicator flashing red).
2. Press the UNLOAD button to move the tractor shuttle forward to the
load position.
3. Lift open the paper door on the front of the printer to expose the paper
feed tractors as shown in the following picture.