Printek 8000 - Manual (Page 106)

U S I N G T H E O P T I O N A L S E T U P M O D U L E
100
Initializing
Setup Module
7. The printer will now compare the configuration data in its internal
memory to the data in the Setup Module. If the data are not an exact
match, the printer will proceed with step 8.
If the data in the printer and the data in the module are an exact
match, installation is complete and the printer will complete its
power up procedure.
8. The printer has now determined that the data in the Setup Module
does not exactly match the data in the printer’s internal memory.
The printer will now display the following message, the ONLINE
indicator will flash yellow and the bell will beep to get the operator’s
attention. Proceed to step 9.
New Setup
Module Detected
9. Press the ONLINE button. The printer will now stop flashing the
ONLINE indicator (will remain yellow) and display the following
message. You must now make one of the selections as described
below.
←
Copy to Printer
←
Copy to Module
If you wish to copy the Setup data to the printer from the Setup
Module, press the button indicated by the arrow next to
Copy to
Printer (the SETUP button). The printer will display the following
message and will now be configured according to the information that
was in the Setup Module.
Copying Setup
to Printer