Printek 8000 - Manual (Page 107)

U S I N G T H E O P T I O N A L S E T U P M O D U L E
101
If you wish to copy the Setup data to the Setup Module from the
printer, press the button indicated by the arrow next to
Copy to
Module (the ALIGN PRINT button). The printer will display the next
message and the Setup Module will now contain a copy of the Setup
information in the printer.
Copying Setup
to Module
After one of the above selections is made, installation is complete, the
ONLINE indicator will be turned off and the printer will finish its
power up procedure. If you are not sure which button to press, refer
to either of the following sections for more information.
Using the Setup Module to Maintain a
Backup Copy of Setup Information for a Single Printer
This use of the Setup Module provides a method of automatically
maintaining a copy of the Setup configuration in case a printer should ever
need to be repaired or if it is replaced under a service contract.
To use the Setup Module in this manner, you only need to perform the
installation procedure once and then forget about it. The printer will
automatically keep the Setup Module updated with any changes that are
made to the printer using the front panel Setup as described in “Printer
Configuration” beginning on page 39. As long as the Setup Module
remains on the same printer, the installation procedure will not have to be
repeated.
If the printer does someday require repair or replacement, simply perform the
installation procedure again on the repaired or replacement printer and in
step 9 choose “Copy to Printer”. Depending upon what was repaired in the
printer, the Setup information in the printer’s memory may not have been
changed. In this case the printer will power up normally and no message
will be displayed.