Pelco ESPRIT ES30C - Manual (Page 9)

C309M-J (9/04) 9
PROGRAMMING - ES30C16/ES31C16
Backlight comp Off
Zoom limit x- -
Reset camera
Next
Exit
Camera Menu
Line Sync On
Line Sync Phase 0
Exit
Line Sync Menu
Power Up Default
Exit
Power-Up Menu
Wiper Mode Momentary
Wiper Dwell 2
Wiper Time 60
Exit
*Wiper Menu
Limit Stops Off
Set Man Limits
Clear Man Limits
Set Scan Limits
Clear Scan Limits
Exit
Limit Stop Menu
Proportional pan On
Park time minutes 0
Scan Speed deg/s 25
Pattern Length 1.5 min
Spd Profile
Exit
Other Menu
Gain Limit 27
Exit
Gain/AGC Menu
Auto-iris mode Auto
Auto-iris level 66
Auto-iris peak
Exit
Auto Iris Menu
Shutter speed Auto
Auto focus mode Auto
Prev
Exit
Next Menu
*
Exit
MAIN MENU
Auto Sharpness On
Sharpness 5
Exit
Sharpness Menu
Auto white bal Auto
R-Gain
B-Gain
Exit
White Balance Menu
Video Blank Zone 1 Off
2 Off
3 Off
4 Off
5 Off
6 Off
7 Off
8 Off
Exit
Zone Blank Menu
Set Azimuth Zero
Az/El
Az/El Line
Direction
Direction Line
Zoom
Zoom Line
Disp Duration
Exit
Az/El/Direction
PRESETS
The following presets are
reserved for special functions.
Preset Function
1 Park
33 Flip
command
34 Pan zero command
90-91 Manual limit stops
92-93 Auto limit stops
95 Select camera
programming menu
96 Stop a scan
97 Random scanning
98 Frame scanning
99 Auto scanning
*ES31C only
1. Access main menu (preset 95).
2. Make main menu selections.
Joystick: Move up or down to position cursor or
to toggle between selections.
Iris Open: Enter.
Iris Close: Cancel.
NOTE: For American Dynamics
controllers with only 32 presets,
set Esprit DIP switch SW1-5 to
the ON position. When SW1-5
is ON, preset
99 becomes 32
98 becomes 31
97 becomes 30
96 becomes 29
95 becomes 28
94 becomes 27
93 becomes 26
92 becomes 25
91 becomes 24
90 becomes 23
89 becomes 22
88 becomes 21
If the limit stops are turned off
(refer to the
Limit Stops section),
presets 23-26 can be used as
regular presets.
For detailed instructions,
refer to the following sections.
Menu items are listed alphabetically.