Philips FW-V220/21 - Manual (Page 32)

32
English
3139 115 20823
GENERAL
System does not react when any – Press STANDBY-ON to switch the system
button is pressed. off. Remove the AC power plug from the wall
outlet, then reconnect the power plug and
switch on the system again.
No or poor sound. – Adjust the volume.
– Disconnect the headphones.
– Check that the speakers are connected
correctly.
– Check if the stripped speaker wire is clamped.
– Make sure the MP3-CD was recorded within
32-256 kbps bit rate with sampling frequencies
at 48 kHz, 44.1 kHz or 32 kHz.
Reversed left and right sound. – Check the speaker connections and location.
Lack of bass sound or apparently – Check the speaker connection for proper
imprecise physical location of musical phasing, coloured/black wires to coloured/
instruments. black terminals.
Remote control has no effect on the – Select the source (VCD, TUNER, etc.)
system. before pressing the function button (Й,н,л,
etc.).
– Reduce the distance to the system.
– Insert the batteries with their polarities
(+/- signs) as indicated.
– Replace the batteries.
Timer is not working. – Set the clock.
– Press CLOCK•TIMER to switch on the timer.
– If recording is in progress, stop recording.
Clock setting is erased. – Reset the clock.
System displays features – Press and hold Ç (on the system) for
automatically;buttons flash five seconds to switch off the
continuously. demonstration.
All lighted buttons are not lit. – Press DIM until DIM OFF display mode is
shown.
Troubleshooting
pg 01-032/V220/21-Eng 28/05/2001, 09:03 AM 32