Philips FW-V220/21 - Manual (Page 29)

29
English
3139 115 20823
Clock/Timer
3 Press à or á on the system to set the hour
for the timer to start.
4 Press í or ë on the system to set the minute
for the timer to start.
5 Press CLOCK•TIMER to store the start time.
➜ The timer is now set.
➜ The
TIMER remains on the display.
¶ At the preset time, the timer will be activated.
➜ The selected source will be played.
Notes:
– During timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting
mode automatically.
– If the source selected is TUNER, the last tuned
frequency will be switched on.
– If the source selected is VCD, playback will begin
with the first track of the last selected disc or other
trays if disc is empty. If all the disc trays are empty,
the TUNER will be selected instead.
– The timer will not activate if a recording is in
progress.
To switch off the TIMER
1 Press and hold CLOCK•TIMER for more than
two seconds.
2 Press Ç on the system to cancel the timer.
➜ The timer is now switched off.
➜ The display will show "OFF" and the
TIMER
disappears.
To start the TIMER again (for the same
preset time and source)
1 Press and hold CLOCK•TIMER for more than
two seconds.
2 Press CLOCK•TIMER again to store the start
time.
➜ The timer is now on.
➜ The
TIMER appears on the display.
Cleaning the Cabinet
¶ Use a soft cloth slightly moistened with a mild
detergent solution. Do not use a solution
containing alcohol, spirits, ammonia or abrasives.
Cleaning Discs
¶ When a disc becomes dirty,
clean it with a cleaning cloth.
Wipe the disc from the centre
out.
¶ Do not use solvents such as
benzine, thinner, commercially
available cleaners, or antistatic
spray intended for analogue records.
Cleaning the DISC lens
¶ After prolonged use, dirt or dust may
accumulate at the disc lens. To ensure good
playback quality, clean the disc lens with Philips
CD Lens Cleaner or any commercially available
cleaner. Follow the instructions supplied with
cleaner.
Cleaning the Heads and the Tape Paths
¶ To ensure good recording and playback quality,
clean the heads, the capstan(s), and pressure
roller(s) after every 50 hours of tape operation.
¶ Use a cotton swab slightly moistened with
cleaning fluid or alcohol.
¶ You can also clean the heads by playing a
cleaning tape once.
Demagnetizing the heads
¶ Use a demagnetizing tape available at your
dealer.
Maintenance
pg 01-032/V220/21-Eng 28/05/2001, 09:03 AM 29