Philips FW-V220/21 - Manual (Page 12)

12
English
3139 115 20823
Operating the System
STANDBY-ON
PROGRAM DIM
C D 1 • 2 • 3 BAND TAPE 1 • 2 VIDEO
O
P TI
M AL JA
ZZ
R O
CK
TE
C H N
O
RECORD DUBBING A.REPLAY
VOLUME
CLOCK•TIMER
MICROPHONE - LEVEL
VCD MP3-CD MINI HIFI SYSTEM
VCD
STOP•CLEAR PLAY• PAUSE
RETURN PBC
DEMO STOP
PAL/NTSC
SEARCH•TUNING PREV NEXT PRESET ▲ ▲
MP 3 -CD ALBUM + TITLE +
D
B
B
DSC
TUNER TAPE AUX
Important:
Before you operate the system, complete
the preparation procedures.
Plug and Play
The system provides PLUG and PLAY feature
that allows you to store all available radio
stations automatically upon power up.
If the PLUG and PLAY has not been
installed
1 Upon power up, “
AUTO INSTALL - PRESS
PLAY” will be displayed.
2 Press PLAY (on the system only) to start
installation.
➜ “INSTALL” will be displayed and followed by
“
TUNER” and then "AUTO".
➜ The PROG starts flashing.
➜ PLUG and PLAY will start searching for all
radio stations on FM band and then followed by
radio stations on MW band.
➜ All available radio stations with sufficient
signal strength will be stored. Up to 40 presets
may be stored.
➜ The last preset radio station will appear on
the display when PLUG and PLAY is completed.
To reinstall the PLUG & PLAY
1 In Standby or Demostration mode, press and
hold
PLAY for five seconds (on the system only)
“
AUTO INSTALL - PRESS PLAY” will be
displayed.
2 Press PLAY (on the system only) again to start
installation.
¶ To exit without storing the PLUG and PLAY,
press Ç button (on the system only).
Notes:
– PLUG and PLAY will be reinitiated again during
the next power up if :
i) PLUG and PLAY installation was not
completed.
ii) No stereo frequency being detected during
PLUG and PLAY, " CHECK ANTENNA" will be
displayed.
– You can store any radio stations manually or
automatically after PLUG and PLAY.
– When PLUG and PLAY is used, all previously
stored radio stations will be replaced.
– During PLUG and PLAY, if no button is pressed
within 15 seconds, the system will go to
demonstration mode (if demonstration mode is
enable)
pg 01-032/V220/21-Eng 28/05/2001, 09:03 AM 12