Polaris Sportsman 6x6 - Manual (Page 85)

82
MAINTENANCE AND LUBRICATION
Engine Cooling System
Coolant
To ensure that the coolant maintains its ability to protect the engine, we
recommend that the system be completely drained every two years and
a fresh mixture of antifreeze and water added. Polaris recommends the
use of Polaris Premium 60/40 anti-freeze/coolant or a 50/50 mixture of
high quality aluminum compatible anti-freeze/coolant and distilled
water. Polaris Premium 60/40 is already premixed and ready to use.
Do not dilute with water. See page 113 for the part numbers of Polaris
products.
NOTE: Always follow the manufacturer’s mixing recommendations
for the freeze protection required in your area.
Any time the cooling system has been drained for maintenance or
repair, replace the coolant. If the recovery bottle has run dry, the level
in the radiator should be inspected. Add coolant as needed.
Radiator Coolant Level
WARNING
Escaping steam can cause severe burns. Never remove the
pressure cap while the engine is warm or hot. Always allow the
engine to cool before removing the pressure cap.
1. Access the radiator pressure cap
by removing the four screws
securing front rack (1). Remove
the front cover (2) by placing
your fingers under the front of
the cover and pulling upward.
2. Remove the pressure cap.
3. Using a funnel, slowly add
coolant as necessary through the
radiator filler neck.
4. Replace the pressure cap and
secure the front cover and rack.
NOTE: Use of a non-standard pressure cap will not allow the
recovery system to function properly. Contact your dealer for
the correct replacement part.
1
2