Philips DECT 221 - Manual (Page 22)

www.philips.com/faqs/dect
20
www.philips.com/faqs/dect
21
Changing PIN
A PIN (personal identification number) code is required to access the registration and delete handset mode.
The factory preset code is “0000”. You can change it to a unique code of your own. A PIN code can be up to
8 digits long.
1. Press the MENU key.
2. Select SETTINGS and press the OK key.
3. Select PIN CODE and press the OK key.
4. Enter the current PIN and press the OK key.
5. Enter the new PIN and press the OK key.
6. Repeat the new PIN.
7. Press
the OK key to confirm.
If you forget your PIN, the only solution you have is resetting your phone (please see below). After this operation the
new PIN will be the default PIN “0000”.
Resetting
You can reset the display, sounds, and other settings of your phone. Refer to the section of Default settings (Page 31).
1. Press the MENU key.
2. Select SETTINGS and press the OK key.
3. Select RESET and press the OK key.
4. Press the OK key again to confirm.
Unsuccessful change
You will hear a reject tone if the new PIN is not repeated correctly. Follow steps 3 to 7 and try again.
SYSTEM