beautypg.com

Troubleshooting – Philips DECT 221 User Manual

Page 33

background image

www.philips.com/faqs/dect

32

www.philips.com/faqs/dect

33

Troubleshooting

Problems

Solutions

The phone does not work at all.

Make sure that the adapter and the phone cord are connected

properly.

Check that the batteries are fully charged and installed properly.

This phone does not work during power failure.

The phone does not ring.

Make sure the adapter and the phone cord are connected

properly.

Move the handset closer to the base unit.

Make sure the handset ringer is turned on.

There is no dial tone.

Check that the phone cord is connected properly.

Check the handset is fully charged.

Move the handset closer to the base unit.

Caller ID does not work properly.

Check with your local phone company that the Caller ID

service is subscribed to.

Let the phone ring at least once before answering.

The second call (Call Waiting) cannot be

answered.

Check with your local phone company and select the correct

recall duration *.

The empty battery icon appears soon

after the batteries are charged.

Replace the batteries with new ones.

The handset is unable to register (DECT

221 only)

Make sure that the

PAGING key has been pressed for

4 seconds before pressing the

OK key .

Each base can only register up to four handsets. See Section 9

- Un-registering a handset - to un-register a currently registered

handset.

The answering machine does not record

calls (DECT 225 only).

Make sure the answering machine is connected to the power

adapter, and the power adapter is plugged into mains supply

which is switched on.

Check to see if the answering machine is full. If so, delete some

or all messages.

Try switching off the power at the main socket, and then turn it

on again after 15 minutes.

Unable to perform remote operation

(DECT 225 only).

Make sure you entered the correct security code.

Use a phone set on tone dial mode.

If the above solutions do not help, remove the power from both the handset and the base. Wait for 15 minutes
and try again.

APPENDIX

*Country dependent

This manual is related to the following products: