POLAR CS600 - Manual (Page 49)

information, see Limited Polar International Guarantee.
For more information on local after sales services, consult Polar Customer Service Card.
Changing Batteries
Have the battery replaced by an authorized Polar Service Center. Avoid opening the sealed battery
cover, but if you choose to change the battery yourself, follow the instructions carefully on the next
page.
To change the batteries of the cycling computer and transmitter yourself, carefully follow the
instructions in Changing Cycling Computer Battery. Instructions apply for all batteries.
If you would prefer Polar to replace the battery, contact an authorized Polar Service Center.
Changing Cycling Computer Battery
To change the cycling computer battery, you need a coin and battery (CR 2354).
1. Using the coin open the battery cover by pressing
slightly and turning counter clockwise .
2. Remove the battery cover. The battery is attached to
the cover, which should be lifted carefully. Remove
the battery and replace it with a new one. Be careful
not to damage the threads of the back cover.
3. Place the positive (+) side of the battery against the
cover and negative (-) side toward the cycling
computer.
4. The sealing ring of the battery cover is also attached
to the cover. Replace the sealing ring if it is
damaged. Before closing the battery cover, make
sure that the sealing ring is undamaged and is
placed correctly in its groove.
5. Put the battery cover in its place and turn the cover
clockwise with a coin to CLOSE position. Make sure
that the cover is closed properly!
Excessive use of the backlight drains the cycling computer’s battery more rapidly. In cold conditions,
the low battery indicator may appear, and disappear again when you return to a warmer environment.
To ensure the maximum lifespan of the battery cover, open it only when changing battery. When
changing the battery, make sure the sealing ring is not damaged, in which case you should replace it
with a new one. Battery kits with sealing rings are available at well-equipped Polar retailers and
authorized Polar Service Centers. In the USA and Canada, sealing rings are available at authorized
Polar Service Centers only.
Keep batteries away from children. If swallowed, contact a doctor immediately. Batteries should be
properly disposed of according to local regulations.
Speed and Cadence Sensors Battery
Contact your authorized Polar Service Center for replacement speed and cadence sensors. The Service
will also test the sensor after replacing the battery.
Power Output Sensor Battery
See the separate Power Output W.I.N.D. Sensor user manual for instructions on how to change the
battery.
Precautions
Interference During Exercise
Electromagnetic Interference and Exercise Equipment
Polar CS600 User Manual 49